If you’re not sure where to start with garden sprinklers, then a Sprinkler Kit will get you going. Refer to our sprinkler layout page (diagram 3 will be most relevant to a start-up kit), and position your sprinklers no further than 1.5mt apart along your Pipe for good watering results. Watering from an edge and throwing into an area using your 1/2 circle (180º) sprays is better than one run of full circle (360º) sprinklers down the middle of an area.
This kit contains 15 x 1/2 circle micro sprays, 5 x full circle micro spinners, 20 of 300mm sprinkler risers, 20 of Stakes to support sprinkler risers, pipe fittings, assorted Garden Tap / water connection fittings, and 16 x clamps for pipe fittings.
The sprinklers in this Kit may even work all at once from the end of a garden hose. If you can’t run everything at once, you will have to break your sprinkler runs into 2 or more groups (see our simple bucket test flow calculation in the flow rate section of our DIY guidance page).
Installation is easy: Decide on your sprinkler positions, dig your pipe trench from your water source to the furthest sprinkler location, select the relevant water connection fitting to connect your 19mm sprinkler pipe, roll out Pipe and connect sprinklers, clamp pipe to fittings, turn on the water, adjust your sprinkler directions.
If splitting is required, do a search in our shopping cart on items 10295 & 10290.
Finally, sit back and watch your garden being watered while you relax!